Expert Answers about Forest River Forester Motorhome

• Installation Instructions for Single Slide Out Momentary Switch
• When installing the Labeled Single Slide-Out Momentary Switch - On/Off/On - White # 37212075 you will want to follow the attached wiring diagram. This is a 5 wire switch, where each motor function will have a positive and negative wire, and the general power to the switch will have it's own pin. The retract function would be on the left side pins and the extend function would be the right side pins.
  view full answer...


• Do I Need to Install a Jumper Wire On the H4 Connector When Switching From Lead to AGM Batteries?
• When you install your AGM batteries you won't need to flip that switch on the Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 60 Amp Power Center # PD4060CSV. You'd only need to flip it if you were using Lithium Ion batteries. However for that H4 connector you are going to want to leave it off for lead. The instructions only recommend installing that jumper if you're using gel batteries, and while AGM batteries do have some gel in them they are not quite...
  view full answer...


• Finding Brake Controller Install Port on 2018 Forest River Forester
• I believe you are looking for the brake controller install port on your 2018 Forest River Forester motorhome which is built on an F-53 chassis. If you check out the picture I attached you can see where the connector is. The harness part # 3035-P is the correct harness to use to install a brake controller like the P3 part # 90195.
  view full answer...


• Adding A Second AC Unit To A 2018 Forest River Forester Motorhome
• To run a second AC unit you're going to need a 50amp system to power both AC units at the same time. I recommend the Furrion Chill HE RV Air Conditioner System - Single Zone - 15,000 Btu - White Item # FR55PV as it's the best overall unit compared to the Atwood and Advent units. You can install it yourself, but AC unit installations can be pretty involved so it's really up to how mechanically inclined you are. I've attached an installation video if you would like to install the unit yourself...
  view full answer...


• How To Tension Chains On Curt Weight Distribution System
• In order to adjust the tension on the Curt Weight Distribution Systems like part # C17002 you will first want to flip the bracket down, towards the ground. Once the bracket is flipped downward you can place one of the links through the hook end of the bracket. Then you can snap the bracket up using the included lift handle (Lift Handle for Curt Weight Distribution Systems part # C17112). If you have a power tongue jack, you can use this to apply tension to the spring bars as well. I have...
  view full answer...


• How To Remove The Factory Frame Bolt To Install A Roadmaster Exact Center Steering Stabilizer
• If there isn't a way to access it from the inner side of the frame or from the side then it would have a weld nut in frame and you would be able to just remove the bolt normally. There unfortunately isn't a guide that shows if there's a standard nut or weld nut in place and Roadmaster's instructions are a bit generalized since stabilizers like the Exact Center # RM47MR you referenced have a somewhat universal fitment. That being said, there would be an access hole somewhere if they used...
  view full answer...


• Can the Command Electrionics LED Trailer Tail Light Be Used On Either Side of the Vehicle
• It won't matter which side you use the LED Trailer Tail Light w/ Reflector and Bracket - Stop, Turn, Tail, License - Red Lens - Driver Side # 328-003-85L or LED Trailer Tail Light with Reflector - Stop, Turn, Tail - Red Lens - Passenger Side # 328-003-85. The wiring on these won't be different and the only difference is that the "drivers" side has the license plate bracket. You can install these on either side of your Forest River RV.
  view full answer...